Nissan VQ35DE Manual de usuario

Forced Induction Racing VQ35DE Install Kit Instructions 2002+ Nissan SE-R Spec-V (W/6spd) Revised Date: 2/16/06 Thank you for purchasing our V

A & B- Add/Remove shims from between the QR engine mount and the adaptor plate, as needed to get your engine as level as possible. Remember, st

Listed above, is where you should insert your 14mm bolt to hold the transmission bracket into the mount. Once you’ve got your engine in place, it’s

Once you get the correct clearance, you will need to drill out the front engine mount to fit the larger, 1/2” diameter bolt. Using the correspond

you get the rear mount in, pivot the front mount adaptor so that it lines up with the QR engine mount isolator. You may have to use the jack to pivot

This one is pretty easy… There’s a second set of holes that are closer towards the block. You will use those, instead of the original holes. Torq

install depth into the transmission. Torque the 12mm bolts to 25ft lbs, and use Red Loc-Tite on the threads! After tightening the 12mm bolts down, g

You will only be able to use those 2 bolts, but it will hold up just fine. Our test car has been running for almost 6 months with this setup. If yo

the QR’s factory fan relay. From there, you can put 12 volts switched to the factory relay, and just run the fans constantly. This will help keep th

Other than that.. good luck with your swap, and if you have any questions, feel free to contact me at [email protected] or 985-713-1542 from 9am to

**BEFORE YOUR BEGIN** This kit was design with simplicity in mind. Installing the VQ drive-train will be fairly straight-forward. However, it will

(1) 1/2” bolt (6” long) 2 washers/1 lock nut (2) 1/2” bolts (5” long) 4 washers/1 lock nut (1) M10 x 1.75 lock nut and 1 washer If you have purchased

Once you have verified the contents of your kit, it’s time to move on to the installation. We will begin, with the assumption that you have remov

Factory Service Manual. If you need the manual for this particular application, it will be saved in a separate folder on this installation CD. Here

use of a high quality clutch alignment tool. This will make the next step a lot easier. Grab a buddy, and have him/her help you lift the transmissio

A. Tighten this nut/bolt down LAST. Torque to 30-35ft lbs B. Tighten these bolts into the block by hand, and just snug them for now. We will torqu

Once you have completed that task, you should install the passenger-side engine mount bracket and adaptor. You should also take the time to bolt y

needed. Torque the stud/nut and bolt/lock washer on the holes marked “B” to 45ft lbs. Remember, it is VERY important that you tighten those bolts in